Every vehicle engine relies on a wide range of working parts to make sure it functions properly and efficiently. If one of these parts begins to wear down, the engine itself will be at risk of malfunctioning. Hydraulic oil pumps are often taken for granted, but they need to receive proper maintenance and care like every other part of the system. A lack of maintenance will make it likely that you need to call for hydraulic repair in Minnesota to replace the pump entirely.
Here are a few of the biggest signs you might need to replace your pump:
- Bad noises: Any loud or unusual noises are never exactly good signs, especially if they’re clanking or scraping sounds. Resolving the noise could be as simple as lubricating the engine to prevent friction from parts that are rubbing together. However, the part could also have come loose or somehow broken apart.
- Low pressure: Oil pumps often are responsible for creating pressure, which helps oil to circulate throughout the whole engine. If you are experiencing low oil pressure, it is typically caused by a defective or malfunctioning pump. A good way to determine whether you have low oil pressure is to check your engine temperature. The higher the engine temperature, the more likely it is that there is insufficient oil pressure, which leads to a buildup of friction within the engine. There are other circumstances that could cause low oil pressure, but the pump should be the first element of the system that you check.
- Age: Simply put, the older an engine and its parts, the more likely they are to fail. If your pumps have been working hard for years and years and you have noticed them starting to fail more often, it’s probably best for you to just replace the part rather than continuing to repair it over and over again.
- Leaks: As you use your pumps regularly over time, it is possible that certain components will begin to wear down, which allows for fluid to leak through them. Depending on the kind of pump you’re using, you could experience either internal or external leaks. You’ll need to use a flow meter to determine how much oil is leaking through the system. This will also allow you to check fluid for contaminants as they leak out. If you notice the leakage is greater than the limit specified by the factory or have seen a significant decrease in the speed of the actuator, it is likely time for you to replace the pump entirely.
Whenever you are experiencing problems with any type of hydraulic equipment, including hydraulic pumps, it is important that you work with a skilled hydraulic repair service in Minnesota to get the issue resolved as quickly and as cost-efficiently as possible. For more information about the services we provide, contact the team at M & M Hydraulic Company today and we will be happy to answer your questions. We look forward to assisting you!